# Filament 3D — PLA Anti-Warp Settings
# Works with ANY printer in PrusaSlicer
# Import: File → Import → Import Config…

[filament:Filament3D PLA Anti-Warp]
filament_type = PLA
temperature = 215
first_layer_temperature = 220
bed_temperature = 60
first_layer_bed_temperature = 65
fan_always_on = 0
disable_fan_first_layers = 5
min_fan_speed = 35
max_fan_speed = 100
fan_below_layer_time = 60
slowdown_below_layer_time = 15
min_print_speed = 15
filament_colour = #FFFFFF
filament_diameter = 1.75
filament_density = 1.24
filament_cost = 0

[print:Filament3D PLA Anti-Warp 0.20mm]
layer_height = 0.2
first_layer_height = 0.25
brim_type = outer_only
brim_width = 10
brim_separation = 0
skirts = 1
skirt_distance = 2
draft_shield = enabled
first_layer_speed = 15
perimeter_speed = 45
infill_speed = 80
solid_infill_speed = 60
top_solid_infill_speed = 40
travel_speed = 180
bridge_speed = 25
gap_fill_speed = 40
perimeters = 3
top_solid_layers = 5
bottom_solid_layers = 4
fill_density = 20%
fill_pattern = gyroid
avoid_crossing_perimeters = 1
support_material = 0